PICkit3 Microchip MPLAB PICkit 3 PIC In-Circuit Programmer Debugger for PIC and dsPIC Flash Chips

PICkit3 In-Circuit Debugger, Programmer-To-Go function.
 
Overview
Microchip's PICkit3 In-Circuit Debugger/Programmer uses in-circuit debugging logic incorporated into each chip with Flash memory to provide a low-cost hardware debugger and programmer.
The MPLAB PICkit3 allows debugging and programming of PIC® and dsPIC® Flash microcontrollers at a most affordable price point using the powerful graphical user interface of the MPLAB Integrated 

Development Environment (IDE). The MPLAB PICkit3 is connected to the design engineer's PC using a full speed USB interface and can be connected to the target via an Microchip debug (RJ-11) 

connector (compatible with MPLAB ICD 2, MPLAB ICD 3 and MPLAB REAL ICE). The connector uses two device I/O pins and the reset line to implement in-circuit debugging and In-Circuit Serial 

Programming™.

Key features
1. Full-speed USB support using Windows standard drivers
2. Real-time execution
3. Processors run at maximum speeds
4. MPLAB IDE compatible (free copy included)
5. Built-in over-voltage/short circuit monitor
6. Firmware upgradeable from PC/web download
7. Totally enclosed
8. Supports low voltage to 5 volts (1.8v to 5.0v range)
9. Diagnostic LEDs (power, active, status)
10. Read/write program and data memory of microcontroller
11. Erase of all memory types (EEPROM, ID, configuration and program) with verification
12. Freeze-peripherals at breakpoint
13. Program up to 512K byte flash with the Programmer-to-Go

Write a review